baoshen による中国の新しい高速赤レンガ乾燥室

製品市場のさまざまな要件を満たすために, 多孔質耐荷重レンガと非耐荷重中空レンガを 1 つのラインで製造可能; 固いレンガを作るだけではありません (図 H を参照) 耐荷重性ときれいに面した壁の装飾と統合された穴あきレンガ, but also produce insulation bricks and blocks for each part; It can not only produce various products of small size, but also produce products of large size (see Figure J), especially long size wallboard bricks; It can be used to produce solid bricks or bricks with low hole rate, and can also produce products with high hole rate with hole rate greater than 50%. Single layer drying can realize intelligent automatic control, and adjust temperature, pressure and air volume according to different products. 例えば, Baoshen’s single-layer chain plate type quick dryer has set the walking speed for chain drying to be 0.3m-1.5m/min. When the designed dryer is 117m, the drying cycle can be controlled to be 1.3h-6.5h, and the commissioning range is relatively large.

If the product changes during production, when the air supply temperature and pressure are basically unchanged, it is only necessary to adjust the chain plate speed through the frequency converter to achieve a reasonable drying cycle for the production of a variety of products. In the actual production of different products, the drying cycle of Baoshen is adjusted from 2h to 5.5h. 一般的, the drying cycle of solid bricks is about 5h; 20% perforated brick in 3h~4h; More than 40% of hollow bricks and hollow blocks shall be dried in 2h~2.5h. In other words, the higher the porosity, the shorter the drying cycle. If the outer and inner walls are thinner, the drying cycle will be shorter. The above also fully shows that single-layer drying is more suitable for the changing porous brick types in production (>>>To be continued…, the next information forecast: 10 advantages of single-layer drying 4).歴史家 ティモシー・ブルック のレンガ製造プロセスの概要 明王朝 中国: